Solenoidin testaus:
DTC 222/P0755: OPEN IN NO. 2 SHIFT SOLENOID CIRCUIT
1) Turn ignition on. Set gearshift lever to “P” position. Check solenoid function by using test mode No. 4 or Volvo scan tool. See TEST MODE NO. 4. If solenoid operates, check wiring for an intermittent short circuit. If solenoid does not operate, go to next step.
2) Turn ignition off. Connect measuring unit to TCM. Connect ohmmeter between measuring unit terminals No. 20 and 28. If ohmmeter
reads about 10-15 ohms, repair poor terminal contact at TCM connector. If ohmmeter does not read about 10-15 ohms, go to next step.
3) Remove air cleaner housing to access transaxle connector. Disconnect transaxle connector. Connect ohmmeter between transaxle connector terminal No. 22 (Violet wire) and measuring unit terminal No. 28. If ohmmeter reads about zero ohms, go to next step. If ohmmeter does not read about zero ohms, check for open circuit in Violet wire.
4) Disconnect transaxle connector. Connect ohmmeter between transaxle connector terminal No. 22 (Violet wire) and ground. If ohmmeter reads 10-15 ohms, repair poor terminal contact at TCM connector. If ohmmeter does not read 10-15 ohms, go to next step.
5) Access and disconnect shift solenoid No. 2. Connect ohmmeter between solenoid terminal and ground. If ohmmeter reads about
10-15 ohms, check for short circuit to ground in Violet wire. If ohmmeter does not read about 10-15 ohms, replace solenoid.
Solenoidiin pääsy edellyttää hieman hommia:
https://www.matthewsvolvosite.com/forums/viewtopic.php?f=1&t=47779