0
0 jäsentä ja 1 Vieras katselee tätä aihetta.
Muistelisin, että 25mm siitä mihin putki tiivistyy ja itse reikä taisi olla 16mm Itse teetin siihen lohkoon semmoisen "billet"osan jonka naputtelin varovasti lukkoliiman kera pohjaan. Ei ole vuotanut, kuvankin voin tähän kohta laittaa niin ymmärrätte mistä höpisen.
Installation Data1. Mount the turbocharger on the turbine inlet flange. All other connections must be flexible and heavy pipework should be supported. Always pre-lube with clean engine oil.2. Always position the bearing housing so that the oil drain is at the bottom and kept within 22˚ of the vertical centre line when installed on the engine.3. Oil should be filtered below 15/20 microns. The oil quality must be as specified by the engine manufacturer. e.g. API - CD (MIL - L - 2104C). Improvement in life can be obtained by using super high performance diesel (SPHD) oils, particularly where extended oil drain periods are used.4. Oil pressure must show at the turbocharger oil inlet within 3 - 4 seconds of engine firing to prevent damage to turbocharger bearing system from lack of lubrication.5. The minimum oil pressure, when the engine is on load must be 210 kPa [2.0 kgf/cm 2 , 30 lbf/in 2 ] and pressures up to 415 kPa [4.0 kgf/cm 2 , 60 lb/in 2 ] are satisfactory. Under idling conditions the pressure should not fall below 70 kPa[0.7 kgf/cm 2 . 10lbf/in 2 ].6. The oil inlet pipe should be 9.5 mm [0.375 in.] bore minimum and the oil drain pipe should be 19 mm [0.75 in.] bore minimum. The oil must drain downwards by gravity from the turbocharger into the engine under all operating conditions.7. Air cleaner pressure drop should not exceed 500 mm [20 in.] of water. Avoid damp/wet air conditions in filter as thiscan dramatically increase pressure drop on a temporary basis.8. The exhaust back pressure after the turbocharger should not exceed 500 mm [20 in.] of water. Consult Holset where high restrictions are expected, particularly when exhaust brakes are to be used.
Tälle ois kova kiinnostus + mitä mahtaisi maksaa
Jos ne jotain kuuden eekkerin tienoilla on hinnaltaan, niin miksei tännekkin? :hello:
En tiedä tarkkaa hintaa vielä, mutta epäilen että hinta tuosta vielä vähän nousee.
Jos päästään yli 12€, niin voisin ottaa yhden.
oma versio:Ensin kierteet lohkoon alkuperäiseen reikään. Sitten siihen sopiva muhvi kierrelukitteella ja alkuperäisellä tiivisteellä paikoilleen.(Kuva poistettu lainauksesta.)Tää meni paikoilleen hiukan muokattuna. Sitten vaan liitin ja letkua kiinni(Kuva poistettu lainauksesta.) (Kuva poistettu lainauksesta.)yläpää kans toteutettu an-liittimellä.(Kuva poistettu lainauksesta.)
Paljonko on sisähalkaisija tuosta mutkan kohdalta?