Jelppii kaipaisin.. En oikein sisäistä ton pwm modin asennusta.. Megamanuaalista :
You will also have to put a 1N4001 diode across the PWM Idle valve itself - the banded end goes to the 12 Volt supply, the non-banded end goes to the lead that goes to MegaSquirt® (this diode is for flyback purposes on the idle valve).
Johonki väliin siis diodi? 850 tyhjäkäyntimoottoriinhan menee kolme johtoo joista yks on kait maa ja kaks menee eculle vakiona.. Eli miten johdotus menee, kun taas diyautotunen sivuilla lukee:
To wire this up without the relay board (directly to the ECU), wire up the hot wire from the idle valve to switched 12v+, and wire the negative wire from the idle valve directly to pin 30 on the MegaSquirt DB37.
(mulla ei ole tuota releboksia)