Fit a 36V Zener Diode in reverse into position D2. Note, the Zener Diode must be fitted backwards, so the
strip on the diode is the opposite end to the stripe on the main board! (This component is part of the kit from
good suppliers) b) Ensure C30 is fitted. (This is needed for noise elimination) c) Ensure D1 is fitted. d) Ensure R12 is fitted (390R 1/2W) e) Solder a jumper from XG1 to XG2. In exceptionally noisy situations it might be required to remove that jumper
and instead runs XG1 out through a spare connection on the DB37 and through the wiring harness direct to the
engine.
Onhan nämä myös tehtyä tarkoin ohjeen mukaan? esim D2 laitettu tuon ohjeen mukaan?