No itseasiassa olin tarkistanu ainakin kymmenen kertaa kunnes huomasin et r43 puuttus. Nyt sekin paikassa eikä kipinää. Tarkistellu taas ainakin 5 kertaa enkä ole löytäny puutteita.
No r43 puuttuminen ei pitäis vaikuttaa megalle tulevaan vr signaaliin..
Tarkista nyt viellä kerran noi vr kytkennät
http://www.msextra.com/doc/ms2extra/Ignition_Pixs/VR_IN_V3.GIFSit tällänen huomio olis D24 kohalla megamanuaalissa:
"Note that this items was originally a 1N4001. However, testing showed that the 1N4148 switching diode has a much faster reverse recovery time which can help with high speed, high voltage signals such as you might get with a missing tooth wheel."
Kuten huomaat tossa kytkentäkaaviossakin on viellä 1N4001 merkattuna. Kyllä se silläkin mitä luultavimmin toimii.
Ja sit potikoiden säätöohje
http://www.megamanual.com/ms2/vradjust.htmTästä olis hyvä lähtee "To adjust the screws for the pots for VR sensor operation, the pot on the transistor base (R56) should be adjusted as near zero as possible (fully counter clockwise), as this is where the VR signal is most stable (all other settings depend on the slope of the signal's rate of change, and hence on the speed of the VR sensor and it's maximum voltage). The pot on the op-amp feedback (R52) needs to be turned to maximize resistance (i.e. give 100K feedback hysteresis). This should be with both screws turned fully counter-clockwise. The pots don't actually stop when fully counter clockwise, instead they have a clutch that lets them spin at the end of their travel. You might be able to hear and feel a slight click when this happens. "
Olettaen nyt että se sun vehe oli ms2 v3.